Metal Clay Supply House - Your one stop shop for all your metal clay supplies need.

You are here: Home > Molds and Stencils > Molding Materials

Sort By:

Page of 1

Cork Clay

Our Price: $9.50

Shape and use as a framework for hollow forms. Dry thoroughly. Cover with metal clay leaving a hole for the Cork Clay to burn away during firing. (8oz) WHEN USED WITH ART CLAY, CORK CLAY MUST BE KILN FIRED!

2 Part Silicone Mold Mix - 5oz.

Our Price: $19.50

Two-Part Silicone Molding Compound - 2 x 5oz. jars. Knead equal parts of this compound together until completely blended; then simply press in an object and allow to set. Sets in 5 minutes and fully cured in 10 minutes. Create molds that capture amazing detail. This product comes in two 5oz jars. Needs no release agent! This product has a maximum shelf life of 6-8 months, but the molds you make will last indefinitely. Instructions: Measure out equal amounts of each part of the molding compound. Combine the two parts and knead thoroughly until there is no marbling. Place the molding compound on a flat surface and press the object to be molded into the compound. Allow the molding compound to set for at least 5 minutes. To test the compound, press your fingernail into an obscure area. If the impression of your nail stays in the compound, it has not yet set. If the impression does not stay, the compound is most likely set. We always recommend that new users begin with small amounts of this product until they get the process down. Please remember, overworking the compound may cause it to set too quickly, or even cause it to set during the kneading process. In addition, not kneading the compound enough may delay the time it takes to set, or cause uneven setting. Unequal amounts of the product may also cause undesired results.

2 Part Silicone Mold Mix - 10oz.

Our Price: $35.00

Two-Part Silicone Molding Compound (Large) 2 x 10oz. jars.
Knead equal parts of this compound together until completely blended; then simply press in an object and allow to set. Sets in 5 minutes and fully cured in 10 minutes. Create molds that capture amazing detail. This product comes in two 10oz jars. Needs no release agent!
This product has a maximum shelf life of 6-8 months, but the molds you make will last indefinitely.

Instructions:

Measure out equal amounts of each part of the molding compound.

Combine the two parts and knead thoroughly until there is no marbling.

Place the molding compound on a flat surface and press the object to be molded into the compound.

Allow the molding compound to set for at least 5 minutes.

To test the compound, press your fingernail into an obscure area. If the impression of your nail stays in the compound, it has not yet set. If the impression does not stay, the compound is most likely set.

We always recommend that new users begin with small amounts of this product until they get the process down. Please remember, overworking the compound may cause it to set too quickly, or even cause it to set during the kneading process. In addition, not kneading the compound enough may delay the time it takes to set, or cause uneven setting. Unequal amounts of the product may also cause undesired results.

Oyumaru (reusable mold material)

Our Price: $6.99

Heat softened molding material. Reusable. (1.4oz)
Directions: Dip the Oyumaru into hot water (more than 176ºF) for 3 minutes. Take the Oyumaru out of the water with a pair of tongs and wipe it dry with a towel. While it is still soft, press the material you wish to mold into the Oyumaru. If the Oyumaru gets hard while you are working with it, place it back in the water and beging the process again.